How Do You Drill Keyhole Slots?

When it comes to drilling keyhole slots, there are a few things you need to take into consideration. The size of the bit, the depth of the hole, and the type of wood you’re working with will all play a role in how successful your project turns out.

Let’s start with the size of the bit. You’ll want to use a bit that’s just slightly wider than the width of your keyhole slot.

This will ensure a tight fit and prevent the slot from being too loose.

Next, you need to consider the depth of the hole. For most projects, a depth of 1/8″ is plenty.

But if you’re working with thicker wood, you may need to go up to 1/4″. Just be sure not to drill too deep, or you’ll risk going through the other side of the wood.

Finally, you need to take into account the type of wood you’re working with. Softer woods like pine or cedar will be easier to drill through than harder woods like oak or maple.

But regardless of the type of wood, always start with a smaller bit and work your way up if needed. It’s always better to err on the side of caution when drilling keyhole slots.

Now that you know the basics, let’s get started. First, mark out where you want your keyhole slot to be. Then, using a drill press or hand drill, start drilling at a slow speed.

Once you’ve got started, you can increase the speed and apply more pressure. But be careful not to overdo it – too much pressure can cause the bit to slip and ruin your project.

Once you’ve drilled through the wood, remove the bit and clean up any debris that’s left behind. Then insert your key into the slot and check for fit.

If it’s too loose, try drilling again with a slightly larger bit until you get a tight fit. And that’s all there is to it! With these tips in mind, drilling keyhole slots is easy and straightforward – give it a try on your next project!.