Are All Table Saw Miter Slots the Same?

Most table sAWS have miter slots cut into the top of the table saw surface and they are used for mounting the fence. The miter slots are also used for holding jigs and other accessories.

The miter slots on most table sAWS are cut to a standard size of 3/4″ wide by 3/8″ deep. Some table sAWS have miter slots that are slightly wider or narrower, but they are generally close to those dimensions.

There are a few different ways that table saw manufacturers cut the miter slots into the table. Some manufacturers use a router to cut the slots while others use a special jig that is mounted on the table saw.

The jig method is generally considered to be more accurate and it produces a cleaner cut.

The miter slots on your table saw should be clean and free of any burrs or roughness. If the miter slots are not clean, it can cause the fence to not slide smoothly or it can cause the jigs and accessories to not fit properly.

You can use a file or a sanding block to remove any burrs from the miter slots.

Most miter gauges have an adjustable stop that can be used to set the exact depth of cut for each workpiece. The stop is adjusted so that when the workpiece is flush with the top of the table saw surface, the blade will just barely touch the workpiece.

This ensures that each workpiece is cut to exactly the same depth.

The miter gauge on your table saw is an important part of making accurate cuts. Be sure to keep it clean and free of any debris or burrs.

Check the adjustment of the stop regularly to ensure that your cuts are all exactly the same depth. With a little bit of care, your miter gauge will help you make perfect cuts every time.