How Do You Make Fret Slots?

There are a few different ways that you can make fret slots, but the most common way is to use a saw. You will need to make sure that the saw you use is very sharp, and that you have a steady hand.

You will also need to be very careful not to cut yourself.

The first thing you need to do is measure the width of the fretboard. The easiest way to do this is to use a ruler or a tape measure.

Once you have the width, you will need to mark out where you want the slots to be. It is important to make sure that the slots are evenly spaced, so that the frets will be in the correct position.

Once you have marked out the positions of the slots, you can start cutting them. It is important to use a saw that is designed for cutting wood.

If you use a regular saw, it is likely that you will damage the fretboard.

When you are cutting the slots, it is important to go slowly and carefully. If you rush, it is easy to make mistakes and end up with an uneven or jagged edge.

Once all of the slots have been cut, you can then start putting in the frets.

The final step is to sand down the edges of the fretboard, so that they are smooth and even. You can use a fine-grit sandpaper for this. Once you have sanded down the edges, your guitar should be ready to play!.